apply
x
x
addhorizontal
add vertical
delete line
distribute lines
Distribute Lines Active
Select lines and click "Apply" below.
Apply
Cancel
measure tool
Measuring Tool Active
Click outside the measure area or press escape "ESC" to deactivate.
Close Measure Tool
helptutorial
zoom in
zoom out
fit
zoom
new design
clear all
preview
x
Measurement Conversion

⅛ = 0.125
¼ = 0.25
⅜ = 0.375
½ = 0.5
⅝ = 0.625
¾ = 0.75
⅞ = 0.875

Are you sure you would like to use this template? Using the template will remove any lines on your canvas and replace them with the template layout.

Chosing to load the design will reload the current page. Any unsaved work will be lost. This design can be edited or copied as a new design.

Chosing to load the design will reload the current page. Any unsaved work will be lost. This design is locked and can only be copied into a new design.

Any unsaved changes may be lost. Would you like to conitnue to a new design?

Are you sure you would like to clear the entire canvas?

Are you sure you would like to delete that line?

The dimensions are invalid.

We build your organizer to the exact dimensions you provide.

Depth: "
Width: "
Height: "
Price:

Important Notes:
1. Typical organizer dimensions should be 1/8"-1/4" less than the actual interior drawer measurements.
2. Your organizer measurements must allow clearance for uneven drawer walls, exposed screw heads, etc.
3. Usually, organizer heights are 1/2 to 3/4 the height of your drawer sides.
4. We do not refund drawer organizers that do not fit.


By checking "I Approve," you indicate that you have verified your measurements, you have read the Important Notes above, and that you approve your design for manufacture.
I Approve

Would you like to fit or crop your current drawer in the new dimensions?

Fit: The walls will be resized to fit in the new drawer dimensions.

Crop: The walls will maintain size and spacing. The current layout will align with the center of the new drawer dimensions.

One of the following needs corrected:

1. A wall does not intersect with another wall in the opposite orientation.

2. Two walls with the same orientation are too close, touching or overlapping.

3. A wall has an overhang that is too short beyond an intersection.

One of the following needs corrected:

1. A wall does not intersect with another wall in the opposite orientation.

2. Two walls with the same orientation are too close, touching or overlapping.

3. A wall has an overhang that is too short beyond an intersection.

Click "Hide This Pop-Up" to disable this message.

Project title is required.

Your drawer design (Silverware Drawer Divider) has been saved.

This action can only be performed in edit mode.

The measurement tool displays measurements of a two dimensional area (rectangle) in inches. The measure tool rectangle can be stretched by grabbing-dragging the corners and moved by grabbing-dragging the middle and outer lines. When it has been resized, new measurements are displayed..

See the tutorial video for more information.

The distribution line tool distributes a set of vertical or horizontal walls evenly across a drawer. Select the desired walls to be distributed and click "Apply" below the activation button.

See the tutorial video for more information.

There are limits to the size of drawer organizer products.
The maximum depth and width are restricted to 24 in. x 39 in. or 39 in. x 24 in.
The minimum allowable depth is 2 in. and minimum width is 2 in. The height is limited between 1 in. and 6 in.
If the values selected are outside those limits, the tool will recalculate to allowable dimensions.

Any unsaved changes will be lost.

We build to your exact dimensions. These values should be slightly smaller than your actual drawer measurements.

See HELP for more information.