Try Design Tool

Are you sure you would like to use this template? Using the template will remove any lines on your canvas and replace them with the template layout.

Chosing to load the design will reload the current page. Any unsaved work will be lost. This design can be edited or copied as a new design.

Chosing to load the design will reload the current page. Any unsaved work will be lost. This design is locked and can only be copied into a new design.

Any unsaved changes may be lost. Would you like to conitnue to a new design?

Are you sure you would like to clear the entire canvas?

Are you sure you would like to delete that line?

The dimensions are invalid.

Verify your measurements before purchasing & allow proper clearance to ensure fit!

Depth:
Width:
Height:
Price:

Important Notes:
1. Depth is front-back; width is the left-right; Height is floor-ceiling.
2. Ensure that your organizer measurements allow clearance for uneven drawer walls, exposed screw heads, etc. The depth and width of most organizer dimensions are typically 1/4" less than the actual drawer measurements.
3. Usually, organizer heights are one-half to three-quarters the height of your drawer sides.


By checking "I Approve," you indicate that you have verified your measurements and approve this design for manufacture. We do not accept returns on drawer organizers that do not fit.
I Approve

Would you like to fit or crop your current drawer in the new dimensions?

Fit: The walls will be resized to fit in the new drawer dimensions.

Crop: The walls will maintain size and spacing. The current layout will align with the center of the new drawer dimensions.

The wall placement of this drawer design is invalid. One of the below issues has occured:

1. A wall does not intersect with another wall. All walls must intersect with at least one wall with the opposite orientation.

2. Two walls with the same orientation (vertical or horizontal on the screen) are too close, touching or overlapping. Remove one wall and increase the size of the remaining wall as needed.

3. A wall has been created that doesn't connect to another wall. Make sure you connect the divider wall to another, or remove the wall divider entirely.

The wall placement of this drawer design is invalid. One of the below issues has occured:

1. A wall does not intersect with another wall. All walls must intersect with at least one wall with the opposite orientation.

2. Two walls with the same orientation (vertical or horizontal on the screen) are too close, touching or overlapping. Remove one wall and increase the size of the remaining wall as needed.

3. A wall has been created that doesn't connect to another wall. Make sure you connect the divider wall to another, or remove the wall divider entirely.

Click "Hide This Pop-Up" to disable this message.

Project title is required.

Your drawer design (Tool Organizer) has been saved.

This action can only be performed in edit mode.

The measurement tool displays measurements of a two dimensional area (rectangle) in inches. The measure tool rectangle can be stretched by grabbing-dragging the corners and moved by grabbing-dragging the middle and outer lines. When it has been resized, new measurements are displayed..

See the tutorial video for more information.

The distribution line tool distributes a set of vertical or horizontal walls evenly across a drawer. Select the desired walls to be distributed and click "Apply" below the activation button.

See the tutorial video for more information.

There are limits to the size of drawer organizer products.
The maximum depth and width are restricted to 24 in. x 39 in. or 39 in. x 24 in.
The minimum allowable depth is 2 in. and minimum width is 2 in. The height is limited between 1 in. and 6 in.
If the values selected are outside those limits, the tool will recalculate to allowable dimensions.

Any unsaved changes will be lost.